Jumbo Zipper Jig - Choice of Color - Sewing Tool - Zipper Tool - Add Zipper Pull to Zipper Tape - 3D Printed

Zipper jig to be used when adding a zipper pull to zipper-by-the-yard tape. Acts as a third hand to easily attach the zipper pull.

This is the same design as my other zipper jig - just with a larger base.

V slot fits #3, #4.5, #5 zipper pulls.

Reinforced prong end to prevent breaking.

3D printed from PLA plastic.

Measures approximately 3" wide by 4" long by 2-5/8" tall.

May be clamped to table or secured with tape as desired.

To use, simply insert a zipper pull in the V notch, so that the pull is on the inside and the slider for the zipper tape is on the outside, and the flared end is pointing up.

 
*** NOTE: Zipper sliders will stop at different points on the fork. Do not force the slider! ***
Then separate the zipper tape a few inches, and holding the teeth facing the jig, insert the right tape into the right groove and the left into the left groove - at the same time. Then pull downwards on the tapes to push them onto the zipper pull.